Why Is My Water Heater Making Noise?
Short answer: Popping or rumbling usually means sediment has built up in the bottom of the tank, which is common with hard water. Hissing can mean a leak or condensation. Loud banging, or noise from the relief valve, needs a plumber soon.

| Noise | Likely cause | What to do |
|---|---|---|
| Popping or rumbling | Sediment at the bottom of the tank | Flush the tank |
| Hissing or sizzling | Water dripping on the burner or element | Check for leaks; call if you see water |
| Ticking | Pipes expanding and contracting | Usually normal |
| Screeching | Partly closed valve | Open the valve fully |
| Banging (water hammer) | Pressure surges in pipes | Plumber can add arrestors or check pressure |
| Noise from the relief valve | High temperature or pressure | Call a plumber |
How to flush sediment
- Turn gas to pilot or switch off the breaker.
- Close the cold-water supply valve.
- Attach a hose to the drain valve and run it outside or to a floor drain.
- Open a hot faucet, then the drain valve. Drain until the water runs clear.
- Close the drain, refill, then restore power or gas.
If the noise comes with a leak, no hot water or a pilot that keeps going out, see our water heater repair in Arvada page.
When noise means replace
If an older tank keeps rumbling after flushing, or there’s water around the base, it may be near the end. See repair vs replace.
Noisy water heater? Call to discuss your plumbing problem.
Sediment and Arvada water
Minerals in hard water settle at the bottom of the tank. When the burner heats the water, small pockets of water trapped under the sediment boil and pop. Over time the layer gets thicker, the heater works harder, and the tank wears out sooner. See Arvada hard water.
Noise and safety
| Sign | Action |
|---|---|
| Relief valve hissing or dripping | Call a plumber. Temperature or pressure may be too high |
| Rumbling plus water on the floor | Shut off water and power or gas, call now |
| Smell of gas near the heater | Leave the house and call the gas utility |
| Popping only | Flush the tank |
Preventing noise
- Flush the tank once a year.
- Keep the temperature around 120Β°F.
- Consider a water softener for heavy scale.
- Replace the anode rod when worn.
Related pages
Frequently asked questions
Is a noisy water heater dangerous?
Popping from sediment usually is not, but it wastes energy. Relief valve noise or leaks need attention right away.
Can flushing an old, noisy tank cause a leak?
On very old tanks, sediment can be holding a weak spot. If it is over 10 years old, ask about replacement first.
Noise by heater type
| Heater | Common noise | Usual cause |
|---|---|---|
| Gas tank | Rumbling, popping | Sediment on the bottom |
| Electric tank | Crackling, humming | Scale on elements |
| Tankless | Clicking, fan noise | Normal startup; whine can mean scale or fan wear |
When to call
- Noise along with leaks or rust
- Relief valve releasing water
- Noise that gets louder over weeks
- Heater older than 10 years with any new noise
Key takeaways
- Popping and rumbling usually mean sediment, which a yearly flush helps prevent.
- A hissing relief valve or water at the base needs a plumber soon.
- Hard water speeds up sediment build-up.
- A noisy heater over 10 years old is often near the end of its life.
If you are not comfortable flushing the tank yourself, a plumber can do it during a routine visit and check the anode rod, relief valve and venting at the same time.
Noisy water heaters are a common call in Arvada 80004 and around Ralston Valley.
Ask for a written water heater quote before work starts.
Talk with a local Arvada plumbing pro about your problem and your options.





